Step 2 - Resistors

Bend all the leads of the resistors using flat nose pliers as follows:

Then bend the other leg.

First insert all the 220ohm resistors as marked on the PCB in positions:

• • R2

  • R3

  • R4

  • R7

  • R14

Note that the resistors have colour bands around them. the colour bands depict the value of the resistor. The codes are explained -> here

Stick down the resistors with a small piece of masking tape, turn over the board and then solder.

Do the same with the 10K and 470 K resistors.